BOLD MAGENTA part numbers are new for 2023 PARTSCANADA.COM 2023 | ATV/UTV AUDIO/COMMUNICATION & MOUNTS 106 DESCRIPTION PART # Fits Can-Am X3 1.85” roll cage 0502-0567 Fits Honda Talon 2.00” roll cage 0502-0568 iOSPHERE BACKING PLATE MOUNT KITS • Uses the same iOmount device mount technology as all other Klock Werks mounts • Cage mount kit allows the iOsphere to mount on any cage tubing, in any location with the correct clamp strap of the correct tubing size • Cage mount requires one strap clamp, PART #s 0502-0540, 0502-0541, 0502-0542 and 0502-0543 (sold separately; see the GENERAL ACCESSORIES section) depending on the diameter of the mounting location • Make your device mounting system Kustom and tailored to your specific size and needs DESCRIPTION PART # Device mount builder’s kit 0636-0105 KLOCK WERKS DEVICE MOUNT BUILDER’S KIT • Easy-to-install mount that incorporates the iOmounts™ system • Ultra-strong 12 lb.magnetic interface and mount retention lip secure devices in the most severe off-road environments • Attach razor-thin iOadapt™ stainless steel adapter to your device and connect to the powerful iOcore™ magnetic carrier • No special case needed; device is held in place by the strong iOcore magnet and can be adjusted to preferred angle • Builder’s kit includes everything needed to mount the system on most flat surfaces; one semi-sphere, one iOcore (black), two iOadapt stainless steel discs, two iOskin™, 1/4” x 20 bolt and washer to mount semi-sphere • Can be remounted onto other vehicles or for other uses NOTE: Not for use with phones that have inductive charging. NOTE: Not for use with Samsung Galaxy S4 phones. COLOR PART # Black 2120-0938 COLOR PART # Chrome 2120-0939 DUAL USB PORT CHARGERS WITH 1” BALL MOUNT AND SOCKET ARM • Stylish looking handlebar mount comes with 5 volt/2.5 amp dual USB ports, 1” ball attachment (for attaching RAM mount accessories) and water-resistant safety cap with built-in switch • 1” ball attachment can be used to attach any RAM products or aftermarket accessory • Gives convenient mounting, charging and playing options all together for smartphones, GPS, MP3 • Rear of the mount has 15”wire with male coax on the other end with a 48” long battery cord to provide enough length • Water-resistant cap has a hidden built-in switch, which switches off the dual USB built-in lighting and power drain when the cap is closed, protecting your battery drain • Can be connected directly to battery terminals without doing tedious connection through ignition switch wiring • Handlebar mount fits 7/8”, 1” and 11/4” bars and comes with required spacers to fit any of the three handlebar sizes • Includes a medium size double socket arm for 1” ball which can be used with any aftermarket accessory with 1” attachment • This socket design with four side slot openings on both sides allows for almost infinite angle adjustment • Length of arm 3” 2120-0938 2120-0939 0502-0568
RkJQdWJsaXNoZXIy NDI5NTY=