WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES SECTION 18 All part numbers in BLUE are new for 2023. 2023 NEW PRODUCTS 1249 See OLDBOOK For Early Model Applications FOR 99-17 BIG TWINS (EXCEPT TOURING, FXR AND DYNA) AND MOST CUSTOM FRAMES THAT USE A 3/4” AXLE PART # DESCRIPTION CHROME 0401-0087 Standard; 27” L 0401-0088 +3” over stock; 30” L BLACK POWDERCOAT 0401-0089 Standard; 27” L 0401-0090 +3” over stock; 30” L AXLE KITS 0214-0959 3/4” axle kit; for single or dual flange wide hub wheels when no brakes or speedometer drive are required 0214-0960 3/4” axle kit; for use w/ single disc 84-99 FXST Softail hubs w/ Original Equipment bearing spacers removed 0214-0961 3/4” axle kit; for use w/ single disc 84-99 FXST Softail hubs and the Original Equipment springer caliper mount FOR 04-18 SPORTSTERS AND 04-17 DYNA GLIDE MODELS PART # DESCRIPTION CHROME 0401-0084 Standard; 27” L 0401-0083 +3” over stock; 30” L BLACK POWDERCOAT 0401-0086 Standard; 27” L 0401-0085 +3” over stock; 30” L AXLE KITS 0214-0959 3/4” axle kit; for single or dual flange wide hub wheels when no brakes or speedometer drive are required 0214-0960 3/4” axle kit; for use w/ single disc 84-99 FXST Softail hubs w/ original equipment bearing spacers removed 0214-0961 3/4” axle kit; for use w/ single disc 84-99 FXST Softail hubs and the OEM springer caliper mount CUSTOM WIDE SPRINGERS WITH SHOCKS AND TAPERED OVAL REAR LEGS • Arrives bolt-on ready and fully assembled with shocks and includes: fork stem, top nut, crown nut, top clamp and inner and outer springs • Available in 27” stock length or 30” +3” over stock length • Paughco springers will now work with OEM fork locks • Springers do not include headlight or risers • Both springers use standard 1” neck bearings • Distance between where axle goes is approximately 10” • Minimum inside width is approximately 73/4” • Requires the use of Paughco 3/4” axle • Springers do not have fender mounts • Requires the use of a 1999 or earlier front wheel • Made in the U.S.A. NOTE: Overall length is measured from the top of the top clamp to the center of the rear leg pivot. Please note that 27” stock-length forks are the same length as OEM forks used on 48-84 FLH Big Twins. The correct length for the equivalent of an FXSTS springer fork would be +3” over stock (30” total). 0214-0959 0401-0083 0401-0089
RkJQdWJsaXNoZXIy NDI5NTY=