WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES All part numbers in BLUE are new for 2023. SECTION 8 2023 NEW PRODUCTS 556 See OLDBOOK For Early Model Applications DISCLAIMER: SEE PAGE 7 FOR IMPORTANT INFORMATION REGARDING CERTAIN WARRANTY AND EMISSION CONTROL REGULATION COMPLIANCE AND NOISE REGULATION INFORMATION. PART # DESCRIPTION 0925-1080 For 91-22 XL (except 21-22 Sportster S/RH1250S, 22 Nightster/RH975) GRIND OPEN CLOSE DURATION @ .053” VALVE LIFT Intake 34° 50° 264° .500” Exhaust 53° 33° 264° .500” S&S 500 CAMS FOR SPORTSTER ENGINES • S&S Cams are tested on the dyno, street and track before being offered to the public • With hundreds of hours of testing on each cam, you know you are getting the best cam S&S can produce • Bolt-in cams that provide excellent torque with stock or ported heads • Recommended for modified engines up to 89” displacement and 9.0:1 to 10.5:1 compression ratio • Will work in 89” to 100” engines with less than 9.0:1 compression • Normal clearancing checks recommended • 2000-6000 rpm • Works with stock valve springs and stock non-adjustable pushrods • Made in the U.S.A. NOTE: Installer must check coil bind, valve-to-valve clearance, valve-to-piston clearance and cam lobe to case clearance. NOTE: 00-20 XL models with stock flywheels require use of 91-99 style pinion gear PART #s 0921-0001 thru 0921-0005, available separately. FOR 91-99 XL AND 94-99 BUELL PART # DESCRIPTION DS-199196 N4 cams GRIND OPEN CLOSE DURATION @ .053” VALVE LIFT LIFT @ TDC N4 Intake 30° 46° 256° .490” .216” Exhaust 52° 24° 256° .490” .198” N6 Intake 34° 50° 264° .500” .241” Exhaust 56° 28° 264° .500” .212” FOR 00-22 XL (EXCEPT 21-22 SPORTSTER S/RH1250S, 22 NIGHTSTER/RH975) AND 00-02 BUELL PART # DESCRIPTION DS-199077 N6 cams XL AND BUELL CAMS • Cams run to 6500 rpm with stock hydraulic lifters; recommend solids not be installed • Stock base circle sizes allow the use of stock pushrods • N4 is for stock or modified applications and has a slightly higher idle speed, but can be used with stock hydraulic lifters and springs; rpm range of 2500-6500 • N6 is designed for modified 1200s to 80” and/or high-compression pistons: stock springs and hydraulic lifters recommended; rpm range 2500-6500 • Made in the U.S.A. DS-199196 DS-199077
RkJQdWJsaXNoZXIy NDI5NTY=