WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS &MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES All part numbers in BLUE are new for the OldBook. SECTION 7 262 See FATBOOK For Late Model Applications DISCLAIMER: SEE PAGE 5 FOR IMPORTANT INFORMATION REGARDING CERTAIN WARRANTY AND EMISSION CONTROL REGULATION COMPLIANCE AND NOISE REGULATION INFORMATION. PART # DESCRIPTION 212810 For 84-99 Evolution Big Twin w/ stock heads EVOLUTION 96” STROKER SIDEWINDER™ KIT • The 96” kit uses the same bottom end as the 89” kit (45/8” flywheel) with the addition of a Big Bore cylinder kit (35/8”) and 1900 series forged pistons • Fully assembled and balanced; ready for installation • Natural finish NOTE: Not for EFI models. PART # DESCRIPTION 0903-0952 For 78-84 Shovelhead (approximate compression ratio of 8:2:1) 93” HOT SET-UP KIT • Kit comes with 4.500” stroker flywheels assembled with mainshafts and rods, 3.625” bore cylinders, pistons, rings, pins and clips, S&S 514 cam, S&S Super E carb kit, valve springs, adjustable chromoly pushrods, top pushrod tube clips, top motor mount and installation instructions • Use stock heads, cases, tappets and pinion gears • Bearings and seals are not included; must be purchased separately • For replacement pistons and rings, see pages 271-274 • Made in the U.S.A. NOTE: Require motor cases to be bored to accept 3.625” cylinders. NOTE: This project requires a skilled technician. It is the responsibility of the person assembling the parts to check all clearances and assembly specifications.
RkJQdWJsaXNoZXIy NDI5NTY=