WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS &MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES SECTION 7 All part numbers in BLUE are new for the OldBook. 265 See FATBOOK For Late Model Applications DISCLAIMER: SEE PAGE 5 FOR IMPORTANT INFORMATION REGARDING CERTAIN WARRANTY AND EMISSION CONTROL REGULATION COMPLIANCE AND NOISE REGULATION INFORMATION. PART # DESCRIPTION 0921-0560 For 70-84 Shovelhead 86” STOCK BORE STROKE FLYWHEEL KIT • Upgrades 74” and 80” Shovelhead engines to 86” displacement at approximately 9.4:1 or 8.1:1 compression (depending on pistons used) • Includes a dynamically balanced 45/8” stroke flywheel assembly complete with S&S heavy-duty connecting rods and mainshafts • Reuse the stock cylinders, saving cost and retaining stock appearance of the engine • Minor crankcase and cylinder modifications are required that can easily be done with hand tools • Kit requires special pistons which must be ordered separately (Contact S&S for required pistons) PART # DESCRIPTION 0921-0250 For 84-98 Evolution Big Twin w/ carburetor (41/4” stroke) FLYWHEEL ASSEMBLY FOR EVOLUTION MOTORS • Made of high-strength forged steel and designed for stock and high-performance custom applications • Special keyed 6° large diameter tapered sprocket shaft that provides more contact area for increased strength • Standard S&S tapered crankpin and pinion shaft are used for ease-of-service • 81/2” diameter with 41/4” stroke • Kit comes fully assembled, trued and balanced to stock H-D 80” or 96” pistons • Includes flywheel, crankpin and connecting rods • Made in the U.S.A. NOTE: 90-99 applications will require pinion shaft conversion kit PART #33-4148. PART # DESCRIPTION DS-194662 For L83-99 Big Twin; repl. OEM #24281-83 DS-194661 For 74-E81 Big Twin; repl. OEM #24281-74A ROD SETS • Heavy-duty replacements, perfect for stock motors • Meets or exceeds OEM specifications • Come completely fitted and ready to install • Complete set includes a two-hole crankpin, aluminum retainers, bearings, nuts and forged heat-treated steel rods PART # DESCRIPTION 0924-0390 For 84-99 Evolution Big Twin LOWER ROD BEARINGS WITH CAGES • High-quality OE replacement components • Made in the U.S.A. PART # DESCRIPTION DS194027 For 84-99 Evolution Big Twin (.792” wrist pin) DS-194652 For 41-E81 Big Twin HEAVY-DUTY CONNECTING ROD SETS • High-quality, heavy-duty rod sets come complete and ready-to-install • Set includes front and rear rods, crankpin and nuts, steel cages and roller bearings • Rods are deep-forged and heat-treated, .120” wider than stock in the I-beam section and feature rod-to-rod clearance to accommodate strokes up to and including 5” • Crankpin has two oil holes and rod has four slots ground on each side of the throw ends to help maintain the oil film on thrust faces • Made in the U.S.A. NOTE: Installation of rod sets may require additional clearancing of flywheels and cases. DS194027 DS-194662
RkJQdWJsaXNoZXIy NDI5NTY=