BOLD MAGENTA part numbers are new for 2023 V-TWIN TOOLS PARTSCANADA.COM TIRE & SERVICE | 2023 435 PART # DESCRIPTION 3801-0286 Valve guide seal installation tool kit VALVE GUIDE SEAL INSTALLATION TOOLS • Manufactured from high-strength 6061-T6 aluminum for increased durability when compared to plastic installers • Precision fitment onto the seal OD to help the builder center the seal over the valve guide so that a few light strikes from a hammer will set the seal • Radiused top striking surface reduces the likelihood of a burr forming from deformation • Available in a kit of four tools that will install valve guide seals on 99-04 Twin Cam, 84-99 Evolution Big Twin, 86-03 Evolution XL, 66-84 Shovelhead, 48-65 Panhead and 57-E83 Ironhead XL series engines PART # DESCRIPTION 3801-0346 For 17-21 M-Eight LEFT MAIN SEAL REMOVER • Remove crankshaft oil seal without damaging crankcase bore • Made in the U.S.A. PART # DESCRIPTION DS-196159 For 36-99 Big Twin, 57-20 XL and Buell (except 1125R) PISTON PIN BUSHING TOOL • Use to remove and install wrist pin bushings without removing rods from crankcase • Made in the U.S.A. PART # DESCRIPTION DS-196072 For 84-99 Big Twin (except Twin Cam), 86-03 XL PISTON PIN KEEPER TOOL • Used to install piston retaining rings • Made in the U.S.A. PART # DESCRIPTION DS196501 For 73-99 Shovelhead/Evolution, .7919”-.7923” WRIST PIN BUSHING REAMING TOOL • Used to ream wrist pin bushings to the proper inner diameter • Can be used with rods in or out of the motor • Lead-in taper makes it easy to use • Made in the U.S.A. NOTE: Some wrist pin bushings will require a small amount of ball honing to give specified fit (see H-D manual for specifications). PART # DESCRIPTION DS196277 For Twin Cam, .927” wrist pin DS-196094 For Evolution, .791” wrist pin ROD ALIGNMENT TOOLS • Use to check rod straightness without removing the rods from the cases • Alignment tool is 4.5” long • Available in Twin Cam and Evolution applications • Made in the U.S.A. PART # DESCRIPTION DS-196039 5/16” stud installation tool 5/16” STUD INSTALLATION TOOL • Designed to set Twin Cam and Evolution exhaust studs, Shovelhead rocker box studs, 4-speed transmission end studs, Bendix & Keihin carb flange studs and most other 5/16” studs • Made in the U.S.A. DS196277 DS-196094
RkJQdWJsaXNoZXIy NDI5NTY=