T E C H N I C A L A P P A R E L 39 ALPINESTARS MOTORCYCLING COLLECTION + The gas inflator that provides the inflation gas for the airbag’s deployment is located in the inflator housing on the left side of the lower back of the rider. + The Stella Tech-Air® 3’s ECU seal-protection ensures all-weather performance and is certified to function between -20 ºC and +40ºC. + The gas inflator housing, electronic wiring, and the airbag are easily removable. + The gas inflator canisters can be replaced by select Alpinestars dealers and certified Tech-Air Service Centers. + The vest is washable. + The ECU has been tested and CE Certified according to different regulations for electronic, radio devices and electrical safety. + The gas inflator cartridge is CE certified to UNI EN 16263, confirming compliance with the safety standard and certifying that the cartridges can be safely handled and serviced. + According to European statutory law the CE mark is a conformity requirement for the marketing of this product. The following standards apply to this product: + When inflated, the Stella Tech-Air® 3 full chest and full back protection from the airbag is Category II CE Certified to the (EU) 2016/425 EEC European Personal Protective Equipment (PPE) Regulation, according to relevant part of EN1621-4:2013 airbag certification standard, which guarantees an impact protection performance of not less than five seconds after the activation. The impact attenuation performance is Level 2 both for full chest and full back. + Impact protective garment 17092-6 Class C (outer garment), with the outershell constructed from water resistant material. + *Note: + Performance tested according to DOLOMITICERT S.c.a.r.l. M.115.001 Protocol for Airbag Protectors Rev.4_14 10 2018. + For more detailed explanation and warnings, refer to the information to be found in the Tech-Air® 3 System Manual.
RkJQdWJsaXNoZXIy NDI5NTY=