BOLD MAGENTA part numbers are new for 2024 FUEL/AIR SYSTEMS PARTSCANADA.COM ATV/UTV | 2024 723 DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 4-6 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. DESCRIPTION PART # 1/8” ID 3’ Length 877265 25’ Roll 877207 3/16” ID 3’ Length 877266 DESCRIPTION PART # 3/16” ID (CONT) 25’ Roll 877208 1/4” ID 3’ Length 877267 25’ Roll 877209 DESCRIPTION PART # 5/16” ID 25’ Roll 877210 3/8” ID 3’ Length 877269 25’ Roll 877211 PVC VENT LINES • Constructed of soft, flexible plasticized PVC tubing •Safe to use with any type of gasoline or alcohol-type fuel •Smooth hard bore helps prevent interior buildup •Recommended for venting and overflow lines •Flexible down to 0°F •Maximum dry heat temp is 220°F • Sold in 3’ lengths and 25’ rolls •Made in the U.S.A. NOTE: Not for use with fuel-injected engines. DESCRIPTION PART # FUEL LINE, 3’ 1/4”, clear M6219 1/4”, black M62191 DESCRIPTION PART # FUEL LINE, 3’ (CONT) 3/16”, clear M6209 3/16”, black M62091 DESCRIPTION PART # CARB VENT LINE, 5’ 1/8”, clear M6109 1/8”, black M61091 FUEL AND CARBURETOR VENT LINE •This quality-made fuel line will not harden or crack •Fuel line is made of premium polyurethane •Fuel line available in 1/4” and 3/16” ID; carburetor vent line available in 1/8” ID • Fuel line available in 3’ lengths • Carb vent line comes in 5’ lengths •Choice of clear or black •Made in the U.S.A. NOTE: Not to be used with fuel over 10% alcohol. Black Clear DESCRIPTION PART # 3/16” Y-connectors P12-014 3/16” T-connectors P12-018 DESCRIPTION PART # 1/4” Y-connectors P12-015 7/16” O-clips for 1/4” hose 2401-0095 DESCRIPTION PART # 9/16” O-clips for 3/8” hose 2401-0391 FUEL LINE FITTINGS • T- and Y- connectors made from white fuel-resistant plastic (Acetal) •Fitting used to run two hoses into one •May be used with O-Clips or hose clamps •Double ear O-clips are easy to install •For use in low-pressure applications P12-014 P12-018 • Snag-free, smooth, polished finish • Strong, positive clamping strength without damage to the hose •Simple to remove by clipping an ear •Connectors and O-clips sold in packs of 10
RkJQdWJsaXNoZXIy NDI5NTY=