WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES SECTION 5 All part numbers in BLUE are new for 2024. 427 See OLDBOOK For Early Model Applications DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 5-7 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. PART # DESCRIPTION EMIS* 1861-0496 18 x 1.5mm 3 1861-0562 12 x 1.25mm 3 O2 SENSOR PLUGS •Works with any O2 sensor port fitting •Two sizes available: 18 x 1.5mm or 12 x 1.25mm •Sold each •Made in the U.S.A. PART # DESCRIPTION 1861-0790 18mm x 1.5 1861-0791 12mm x 1.25 O2 SENSOR PORT PLUGS •Allow non-sensor HD models to run newer-style exhaust systems equipped with O2 sensor ports •Simply screw into non-essential sensor ports •Sold in pairs •Made in the U.S.A. PART # DESCRIPTION 1861-0784 O2 port bushing adapters O2 PORT BUSHING ADAPTERS •Threaded outer and inner adapters reduce O2 sensor port from 18mm to 12mm allowing riders to use our exhaust pipes on select, newer-model motorcycles •Sold in pairs •Made in the U.S.A. PART # DESCRIPTION STRAIGHT 1861-05601 18mm x 1.5 1861-0561 12mm x 1.25 45° ANGLE 1861-0694 18mm x 1.5 1861-0695 12mm x 1.25 1 Stainless steel. O2 WELD-IN SENSOR BUNGS •Used to install O2 sensors in exhaust systems •Weld-in style •Sold in pairs •Made in the U.S.A. PART # DESCRIPTION EMIS* WELD-IN SENSOR BUNGS 7806-1563 18mm x 1.5 steel 4 1861-0831 18mm x 1.5 stainless steel 4 SOCKET PLUGS 7806-1564 18mm x 1.5 steel 4 1861-0832 12mm x 1.25 steel 4 O2 SENSOR WELD-IN BUNGS AND PLUGS •Allow for easy installation of oxygen sensors •Sold each •Made in the U.S.A. PART # DESCRIPTION 1861-0464 18mm x 1.5 PART # DESCRIPTION 1861-0607 12mm x 1.25 O2 SENSOR PORT PLUG KITS •Allow select pre-closed-loop H-D models to run newer-style exhaust systems equipped with O2 sensor ports •Include two zinc-plated plugs with sealing washers •Simply screw into nonessential sensor ports 1861-0560 1861-0694 1861-0831 1861-0832 1861-0464 1861-0607
RkJQdWJsaXNoZXIy NDI5NTY=