WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES SECTION 6 All part numbers in BLUE are new for 2024. 433 See OLDBOOK For Early Model Applications DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 5-7 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. PART # DESCRIPTION EMIS* WITH O2 SENSORS 1020-4037 For 21-22 M-Eight models w/ software level 28 2 1020-2491 For 14-20 Dresser models 2 1020-2485 For 10-13 Dresser models 2 1020-2483 For 07-09 Dressers, 07-11 FXST/FLST (except 07-11 CVO models), 06-11 Dyna Glide, 08-11 V-Rod, and 07-13 XL models 2 1020-2489 For 12-17 FXST/FLST and 12-17 Dyna Glide models 2 1020-2495 For 14-22 XL models (except RH Sportster models) 2 PART # DESCRIPTION EMIS* WITH O2 SENSORS (CONT) 1020-2487 For 12-17 V-Rod models 2 WITHOUT O2 SENSORS 1020-4046 For 21-22 M-Eight models w/ software level 28 2 1020-2492 For 14-20 Dresser models 2 1020-2490 For 12-17 FXST/FLST and 12-17 Dyna Glide models 2 1020-2496 For 14-22 XL models (except RH Sportster models) 2 1020-2488 For 12-17 V-Rod models 2 TARGET TUNE •Allows the factory ECM to interpret and use wideband O2 sensor signals •Target fuel table from the calibration is achieved in real-time •Retains OEM closed loop and achieves adaptive fuel control strategy •Learns and uses VE table corrections as you ride •Does not interfere with dealer diagnostic/service tools PART # DESCRIPTION EMIS* 1020-2371 POD-300 digital display 4 POD-300 DIGITAL DISPLAY •Real-time fuel adjustment •Display channels real-time: rpm, TP, map position (when using map switch), duty cycle, fuel exchange, ignition change and wideband air/fuel ratio (with WB2 or AutoTune connected) •Weather resistant for use in all conditions •Log channels saved to internal memory and can be viewed/analyzed with Dynojet’s powercore software •High-contrast display, viewable in sunlight •Includes CAN cable for attachment to Power Commander V, AutoTune and Wide Band Power Commander •Made in the U.S.A. NOTE: Not for use with Power Commander III USB. •Includes OEM-style connectors to plug into factory O2 harness, either 2- or 4-pin versions •Available with or without O2 sensor •Made in the U.S.A. 1020-2483 1020-2488
RkJQdWJsaXNoZXIy NDI5NTY=