BOLD MAGENTA part numbers are new for 2024 PARTSCANADA.COM 2024 | OFFROAD BIKE STANDS & ACCESSORIES 88 RAM SOCKET ARM •High-strength composite • Features a long, preassembled extension pole with 1” and 1.5” ball single open sockets •Socket ends swivel 360°, allowing you to rotate the camera adapter in any direction •Pole length (socket end to socket end) is 18” DESCRIPTION PART # RAM socket arm 0603-0942 RAM MOUNT ADAPTERS •Marine-grade aluminum with a black powdercoat finish • 1” rubber ball •Predrilled holes in bases allow mounting to a variety of arms and cradles DESCRIPTION PART # Ball w/ adapter AMPS hole 0603-0471 DESCRIPTION PART # Ball w/ adapter diamond-shaped 0603-0472 RAM MOUNT TOUGH-BALL™ BASE • Features 1” diameter rubber ball connected to a 1/4”-20 x .25” male-threaded post •Male thread matches most standard camera and camcorder female threads found on the bottom of the camera DESCRIPTION PART # RAM Tough-Ball™ base 0636-0065 RAM UNIVERSAL X-GRIP® CELL PHONE CRADLE WITH 1” BALL •High-strength composite and rustproof marine-grade stainless steel construction •Spring-loaded holder expands and contracts for perfect fit on your device •Rubber-coated tips will hold device firm and stable • Includes 1” ball; mount adapter is not required •Versatility of holder allows for attachment to many RAM arms • Cradle Dimensions: Minimum Width = 1.875” (Minimum Height = 4.25”) Maximum Width = 3.25” (Minimum Height = 2.25”) Depth = 0.875” •It is important to verify the dimensions of your handheld device with a case/sleeve/skin when determining the overall size •X-Grip® includes a device tether •Electronic device not included DESCRIPTION PART # X-Grip® cell phone cradle 0603-0478 DESCRIPTION PART # 4-pk. post caps 0603-0645 DESCRIPTION PART # X-Grip replacement tether 0603-0685 DESCRIPTION PART # Universal Finger-Grip™ cradle 0603-0477 RAM UNIVERSAL FINGER-GRIP™ CRADLE •This mount is designed to hold cell phones (check measurements below for dimensions) and electronic devices •High-strength composite •Comes with three sets of four flexible rubber-coated fingers placed along the sides to grip your device •The fingers open by squeezing the ends of the holder •The bottom of the holder includes a back plate that adds support to the device being held by the mount •Can also be used with several other phone accessories • The spine plate contains the universal AMPS and 1.5” x 2” hole patterns •Height dimensions: minimum with top and bottom plates is 5.25” and maximum with top and bottom plates is 6.0” •The top and bottom plates can be removed for larger devices • Spine plate dimensions: 3”W x 3” H •Using short-arm side clamps: maximum depth is 0.75”, minimum width is 1.25” and maximum width is 3.0” •Using medium-arm side clamps: maximum depth is 1.25”, minimum width is 1.5” and maximum width is 3.5” 0603-0472 0603-0471 •Using long-arm side clamps: maximum depth is 1.6”, minimum width is 2.25” and maximum width is 3.5” •Made in the U.S.A. NOTE: Does not come with ball mount adapter; use PART #0603-0472 to mount to RAM double-socket arm. 0603-0478 0603-0685
RkJQdWJsaXNoZXIy NDI5NTY=