BOLD MAGENTA part numbers are new for 2024 PARTSCANADA.COM 2024 | STREET FUEL/AIR SYSTEMS 1044 DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 4-6 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. FITS MODEL PART # EMIS* KTM 690 Duke 12-19 1020-2388 2 SuperDuke R 1290 14-19 1020-2388 2 SUZUKI GSX-R600 01-03 1020-2090 2 FITS MODEL PART # EMIS* SUZUKI (CONT) GSX-R600 04-21 1020-1259 2 GSR-750 (European only) 11-13 1020-1259 2 GSX-R750 00-03 1020-2090 2 FITS MODEL PART # EMIS* SUZUKI (CONT) GSX-R750 04-21 1020-1259 2 GSX-R1000 03-16 1020-1259 2 GSX1300BK B-King 08-12 1020-1261 2 GSX1300R Hayabusa 08-20 1020-1261 2 PCV IGNITION MODULES •Allows user to advance or retard the ignition curve based on throttle position and rpm, and to tune each cylinder individually •Ignition module connects to PCV USB via a built-in expansion port link DESCRIPTION PART # Repl. shift rod “G” 334592 DESCRIPTION PART # Repl. shift rod “H” 334593 REPLACEMENT SHIFT RODS •For Dynojet Ignition quick shifter kits 1 Requires either a Quick Shifter Expansion Module (QEM), Secondary Fuel Module (SFM) or an Ignition Module to use the DQS. See pages 1038-1040 for QEM and SFM; see page 1044 for Ignition Modules. ZX10R 11-15 must also order shift rod C PART #1601-0018. DQS APPLICATIONS FITS MODEL QUICK SHIFT SENSOR TYPE DUAL CONTACT SENSOR TYPE SHIFT ROD TYPE APRILIA RSV Mille 04-09 1601-0014 - - RST 1000 Futura 01-05 1601-0014 - - Tuono 03-05 1601-0014 - - BMW S1000R 14-16 - 1601-0510 - S1000RR 10-18 - 1601-0510 - DUCATI 749/S 03-06 1601-0014 - 1601-0016 848 08-10 - 1601-0512 1601-0016 M800 Monster 03-04 - 1601-0512 1601-0016 M900 Monster 00-01 - 1601-0512 1601-0016 999/S 03-06 1601-0014 - 1601-0016 DS1000 Monster 03-04 - 1601-0512 1601-0016 1098/R 07-08 - 1601-0512 1601-0016 HONDA CB500/CBR500R 13-18 - 1601-0510 - CBR600F4i 01-06 - 1601-0510 1601-0017 CBR600RR 03-20 - 1601-0510 1601-00161 CB650F/CBR650F 14-18 - 1601-0510 - CB650R/CB650RR 19-20 - 1601-0510 - NC700X 12 - 1601-0510 1601-00161 DYNOJET QUICK SHIFTER (DQS) SENSORS USB/V •Races are won or lost in fractions of a second •Dynojet’s Quick Shifter (DQS) kit allows full-throttle, clutchless upshifts in racing and performance riding applications •Shift rod pressure/tension sensor kit is a universal sensor that mounts to the shift rod in either a push or pull configuration; requires modification of gear-linkage tie rod • Linear travel sensor kit works with bikes that have no shift rod, or on those the shift rod sensor will not fit, by mounting one end to the shift lever and the other to a fixed point on the chassis; available in push or pull types with universal mounting hardware •Plugs directly into the Power Commander expansion port with no rewiring required •Power Commander Control Center software lets you set engine dead time during upshifts and minimum rpm for system operation • PART #s 1601-0510 and 1601-0512 “pressure style” sensors for PCV/USB and have two terminals, so it can either act as “push” or “pull” type • PART #1601-0014 is a “linear” sensor for PCIII USB • PART #1601-0247 is a “linear” sensor for PCV NOTE: To order either of the above sensors, you must find the correct direction of movement during an upshift (push or pull). For the shift rod/pressure/tension sensor, press on the shift lever in the direction of an upshift to see if the rod is pushing or pulling on the clevis on the shift shaft. For the linear travel sensor, also move the shifter for an upshift. If movement is down, a pull sensor is needed. If movement is up, a push sensor is required. 1601-0512 1601-0014 •Connects to the ignition coils through an intermediate harness connection or directly to the coil connectors; no cutting or splicing of wires is required •Direct coil driver technology allows a high degree of flexibility in timing adjustments 334593
RkJQdWJsaXNoZXIy NDI5NTY=