BOLD MAGENTA part numbers are new for 2024 EXHAUST PARTSCANADA.COM STREET | 2024 75 DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 4-6 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. DESCRIPTION PART # 62mm 2404-1024 80mm 2404-1025 EXHAUST PIPE SPRINGS •62mm size are stainless steel with a double swivel design •80mm size are zinc-plated steel •Sold in packs of 4 SPRING LENGTH PART # 38mm M7713 57mm M7714 60mm M7715 63mm M7709 SPRING LENGTH PART # 67mm M7710 70mm M7716 75mm M7711 80mm M7717 SPRING LENGTH PART # 83mm M7712 90mm M7718 100mm M7720 EXHAUST SPRINGS •Stainless steel construction gives superior strength and attractive appearance • Swivel hook design eliminates binding, extending spring life •Available for most late-model 2-stroke and 4-stroke models •Sold in pairs •Made in the U.S.A. 2404-1025 DESCRIPTION PART # Exhaust rivet kit 1860-0176 EXHAUST RIVET KIT •Have the right parts ready to complete the job •Steel rivets with corrosion resistant coating •Rivets designed to be pulled by a hand operated rivet gun, no air power needed •Rivet diameter 3/16” with a grip range of .125” to .6” •Kit includes 20 rivets and 1 properly sized 3/16” drill bit •Made in the U.S.A. SIZE PART # 1.75” 094-1750 2.0” 094-2000 2.25” 094-2250 2.5” 094-2500 2.75” 094-2750 3.0” 240223 STAINLESS STEEL T-BOLT CLAMPS •Keep it all together and clean with these heavy-gauge stainless steel clamps, the best in the business •Stainless steel construction resists heat and rust •Sold each •Made in the U.S.A. SIZE PART # 3” L DS-203060 SIZE PART # 43/4” L DS-203070 EXHAUST HANGER BRACKETS •Chromed 1/8” thick steel exhaust hangers •Sold each DESCRIPTION PART # 8” 2120-0144 14” 2120-0145 STAINLESS STEEL CABLE TIES •Perfect for high-temperature applications •Ball bearing and barb fastening assembly locks tightly and will not slip •Use anywhere a normal cable tie isn’t strong enough or can’t take the heat •Two lengths available; sold in packs of five •Made in the U.S.A. 2120-0145 DS-203070 DS-203060 NOTE: When measuring for exhaust spring length, please use points #1 - #3 for reference. 1. Exhaust springs should be measured when they are off the vehicle.Wear eye protection when removing. 2.The length measurement should be taken from inside hook to opposite end inside of hook. 3. For correct fit, an exhaust spring should not be extended more than 20% of its free length.
RkJQdWJsaXNoZXIy NDI5NTY=