BOLD MAGENTA part numbers are new for 2024 V-TWIN TOOLS PARTSCANADA.COM TIRE & SERVICE | 2024 409 PART # DESCRIPTION DS-197064 For 69-02 Big Twin SNAP RING INSTALLER AND REMOVER • Used for removing and installing the Timken® bearing outer race snap ring • A must for replacing rings in OEM and aftermarket cases • Made in the U.S.A. PART # DESCRIPTION 3801-0084 For 03-10 Twin Cam engines PART # DESCRIPTION 3801-0108 Repl. sleeve kit TIMKEN® CASE BEARING TOOL • For building big-cubic-inch, late-model Twin Cam engines • Can also be used to replace bearings for stock 88” or 96” engines utilizing the JIMS precision insert • Easily and accurately converts the left-side crankshaft roller bearing (OEM #24604-00D) to the more durable Timken® bearing (OEM #9028) • Sleeve is several times stronger than stock aluminum case material that standard bearings ride in • Included in kit is one new steel bearing insert sleeve (held to under .0002” total indicator reading), all necessary drill bits to drill oil feed and return holes, press plate that holds bearing sleeve insert in line with case bearing bore at time of installation, all necessary hardware and instructions • Requires normal hand tools, hand drill and two-ton press • Timken® bearing not included; see PART #0924-0108 • Replacement Timken® sleeve kit available separately • Made in the U.S.A. PART # DESCRIPTION 3801-0062 For 06 Dyna models and all 07-17 Twin Cam models CASE SPLITTER TOOL • ”Breaks” the case sealant by pushing apart both case halves • Bolts to primary mounting holes • Uses included hand thread-in pushing screw • Flywheels will be pushed from the left case • Made in the U.S.A. PART # DESCRIPTION 3801-0345 For 17-20 M-Eight 107”, 114” 3801-0130 For 99-17 Twin Cam 88”, 96” or 103”, 3.75”-3.875” 3801-0129 For 99-17 Twin Cam Screamin’ Eagle, 4”-4.060” DS-196212 For 66-99 Big Twin cylinders, 3.4375”-4” bore w/ stock bolt pattern CYLINDER TORQUE PLATES • Torque plates must be used when boring or honing late-model aluminum cylinders • Simulate running stress conditions • Instructions included • Made in the U.S.A. PART # DESCRIPTION 3801-0251 Tappet adjustment tool TAPPET GO-NO-GO TOOL • Simplifies the way to verify proper tappet adjustment • If the tip doesn’t fit between the clip and the pushrod seat or if there is up and down end play, the tappet is out of adjustment • For use on most hydraulic tappets, OEM and aftermarket, for Twin Cam or Evo • Will not work on Solids, JIMS Hydrosolids or other limited travel tappets • Made in the U.S.A. PART # DESCRIPTION 3801-0012 For 03-17 Twin Cam“A” and “B”motors CRANKCASE BEARING REMOVER AND INSTALLER • For use on pinion and sprocket side main case bearings on 03-17 Twin Cam“A”motors • Also works on sprocket side main case bearing on 03-17 Twin Cam“B”motors • Made in the U.S.A. 3801-0084 3801-0345 DS-196212
RkJQdWJsaXNoZXIy NDI5NTY=