2024 Parts Canada Tire & Service

BOLD MAGENTA part numbers are new for 2024 V-TWIN TOOLS PARTSCANADA.COM TIRE & SERVICE | 2024 413 PART # DESCRIPTION DS-196199 For 99-06 Twin Cam (except 06 Dyna) for removing/​ installing cams and bearings; for 00-06 FXST/FL and L00-05 FXD to remove and install cams only CAMSHAFT REMOVAL/​INSTALLATION TOOL • Used to remove and install camshafts and bearings • Provides precision alignment of camshafts in the support plate • Made in the U.S.A. PART # DESCRIPTION DS-196198 For 00-06 Twin Cam motors (except 06 FXD) 3801-0061 For 06 Dyna models and all 07-17 Twin Cam DS-196156 For 58-99 Big Twin, except Twin Cam INNER CAM BEARING REMOVAL TOOLS • Used to remove inner cam bearing without damaging the crankcase • Designed to keep rollers from falling into the crankcase • Instructions included • Made in the U.S.A. PART # DESCRIPTION DS-196170 For 70-99 74” and 80” Big Twins, and 70-03 XL models CAM COVER PULLER • Used to remove the right side-case cover • Includes bracket, puller bolt and set screws • Made in the U.S.A. PART # DESCRIPTION 3801-0066 For 06 Dyna models and all 07-17 Twin Cam models CAM ASSEMBLY TOOL • Holds both cams in an upright position while lowering cam support plate over both guides and cam journal guides • Made from a non-marring material that will not damage cam surface • Made in the U.S.A. PART # DESCRIPTION FOR 99-17 TWIN CAM 3801-0160 Installer tool 3801-0161 Repl. drive for PART #3801-0160 CAM BEARING INSTALLATION TOOL • Used to install the two inner cam bearings • Designed to press from the letter side of the inner cam bearing to eliminate any damage to the bearings, cam or case • Will set bearings .023”-.028” below case surface • Made in the U.S.A. PART # DESCRIPTION DS-196196 For 99-06 Twin Cam motors (except 06 Dyna) CAM CHAIN TENSIONER TOOL • Designed to unload the pressure on the primary and secondary chain tensioners • Also checks spring loads on chain tensioners • Includes instructions • Made in the U.S.A. PART # DESCRIPTION 3801-0310 For Evolution,Twin Cam and M-Eight lifter bores LIFTER BORE MEASURING KIT • A set of precision-ground steel balls to accurately measure lifter bore diameter and bore roundness • Includes sizes 0.8430”, 0.8435”, 0.8440”, 0.8445” and 0.8450” • Made in the U.S.A. PART # DESCRIPTION 3801-0060 For 06 Dyna models and all 07-17 Twin Cam models DS-196201 For 99-06 Twin Cam models (except 06 FXD) CAM/​CRANK SPROCKET LOCK TOOLS • Designed to lock the camshafts and crankshaft sprockets when removing, replacing and torquing the sprocket bolts • Made of non-marring Delrin® • Instructions included • Made in the U.S.A. 3801-0061 3801-0160 3801-0161 DS-196201

RkJQdWJsaXNoZXIy NDI5NTY=