BOLD MAGENTA part numbers are new for 2024 V-TWIN TOOLS PARTSCANADA.COM TIRE & SERVICE | 2024 415 PART # DESCRIPTION 3801-0286 Valve guide seal installation tool kit VALVE GUIDE SEAL INSTALLATION TOOLS • Manufactured from high-strength 6061-T6 aluminum for increased durability when compared to plastic installers • Precision fitment onto the seal OD to help the builder center the seal over the valve guide so that a few light strikes from a hammer will set the seal • Radiused top striking surface reduces the likelihood of a burr forming from deformation • Available in a kit of four tools that will install valve guide seals on 99-04 Twin Cam, 84-99 Evolution Big Twin, 86-03 Evolution XL, 66-84 Shovelhead, 48-65 Panhead and 57-E83 Ironhead XL series engines PART # DESCRIPTION 3801-0346 For 17-21 M-Eight LEFT MAIN SEAL REMOVER • Remove crankshaft oil seal without damaging crankcase bore • Made in the U.S.A. PART # DESCRIPTION DS-196072 For 84-99 Big Twin (except Twin Cam), 86-03 XL PISTON PIN KEEPER TOOL • Used to install piston retaining rings • Made in the U.S.A. PART # DESCRIPTION DS196277 For Twin Cam, .927” wrist pin PART # DESCRIPTION DS-196094 For Evolution, .791” wrist pin PART # DESCRIPTION 3801-0319 For 17-21 M-Eight LEFT MAIN SEAL INSTALLER • Bottoms out when seal properly installed • Allows alternator stator to stay in place • Made in the U.S.A. PART # DESCRIPTION DS-197032 For 84-17 Big Twin (except M-Eight), 86-20 XL and 94-09 Buell (except 1125R) EXHAUST STUD DRILL PLATE • Designed to drill broken exhaust studs • Can be used with most motors still in the frame • Includes drill bushing and 1/4” drill bit • Made in the U.S.A. PART # DESCRIPTION FOR ALL TWIN CAM HEADS DS-196408 Twin Cam compression release installation kit TWIN CAM COMPRESSION RELEASE VALVE INSTALLATION KIT • For big-inch or high-compression Twin Cams • Works on front and back head, with or without valves installed • Simply drill, spot face, tap and install compression release valves • Installation kit includes fixture, drill bit, spot face bit and thread-tapping tool • Thread-tapping tool is also available separately for other uses • Compression release valves must be purchased separately • Made in the U.S.A. PART # DESCRIPTION 53-0040 Allen wrench set ROCKER BOX WRENCH SET • Includes four Allen wrenches of different lengths for those hard-to-get-to rocker box screws • For use on Evolution-style Big Twin and XL motors • Made in the U.S.A. PART # DESCRIPTION 3801-0028 Rocker box cover wrench ROCKER BOX COVER WRENCH • Designed to reach hard-to-get-at 3/16”Allen on the rocker boxes of Big Twin, Sportster and Buell models • Features a 3/8” drive for use with torque wrench • Vinyl cover offers comfort and minimizes chances of damage to finished surfaces ROD ALIGNMENT TOOLS • Use to check rod straightness without removing the rods from the cases • Alignment tool is 4.5” long • Available in Twin Cam and Evolution applications • Made in the U.S.A. DS196277 DS-196094
RkJQdWJsaXNoZXIy NDI5NTY=