BOLD MAGENTA part numbers are new for 2024 V-TWIN TOOLS PARTSCANADA.COM TIRE & SERVICE | 2024 425 PART # DESCRIPTION 3811-0106 For Indian Scout, Chief, Chieftain and Roadmaster AXLE HEX ADAPTER • 14mm x 16mm axle adapter • Developed for front axle removal on Scout, Chief, Chieftain and Roadmaster motorcycles • Made from heat-treated carbon steel PART # DESCRIPTION 3805-0070 For 02-21 FLT/FLHT models THIRD HAND AXLE LOCKER TOOL • Prevents axle from moving while torquing down the axle nut after setting belt tension • Eliminates the need for a helper or trying to blindly hold the axle from the other side of the tire • Made in the U.S.A. PART # DESCRIPTION 147748 For 08-13 FLHT/FLHR/FLHX/FLTR, 05-13 V-Rod REAR AXLE NUT TORQUE ADAPTER • Adjusts the drive belt tension or rear wheel alignment • Saves time by eliminating need to remove mufflers •1/2” drive receiver hole (compatible with 1/2” torque wrench) • Made in the U.S.A. PART # DESCRIPTION 3850-0247 Saddlebag latch and hinge rivet tool SADDLEBAG LATCH AND HINGE RIVET TOOL • Secures saddlebag latches and hinges with rivets, while providing a clean factory look • Made in the U.S.A. PART # DESCRIPTION 3850-0296 Master kit for 96-21 Big Twin models and 96-03 XL MASTER CYLINDER BRAKE BLEEDING SOLUTION • Cleaner way to purge system of air with less fluid used and a reduced chance of cosmetic damage due to brake fluid spillage • Consists of vacuum-bleed device with a transparent cap, which forms a tight seal to the master cylinder and has a fitting to attach a vacuum pump • Master kit includes five different caps and gaskets (vacuum pump not included) • Made in the U.S.A. PART # DESCRIPTION DS196294 For Big Twin and XL 3/8”DRIVE 35MM SOCKET FOR TOP NUT ON FORKS • Used to remove and install top fork nuts on fork tubes • Rubber protector inside socket protects chrome finish • Will clear most handlebars • Made in the U.S.A. PART # DESCRIPTION 3805-0189 For 18-20 FLSB/FXFB models CASTLENUT SOCKET FOR INVERTED FORKS • For removing and installing internal castlenut on inverted forks • Made in the U.S.A. PART # DESCRIPTION 3805-0158 For 49mm fork tubes FORK CAP INSTALLER • Used to install fork tube caps without removing the fork legs from the bike • Made in the U.S.A.
RkJQdWJsaXNoZXIy NDI5NTY=