BOLD MAGENTA part numbers are new for 2024 V-TWIN TOOLS PARTSCANADA.COM TIRE & SERVICE | 2024 429 PART # DESCRIPTION 3807-0378 O2 bung installation kit PART # DESCRIPTION 3807-0398 Refill kit O2 BUNG INSTALLATION KIT • Complete kit to add 18mm x 1.5” threaded bungs for O2 sensors and O2 tuning samplers • Remove heat shields, install bung and tune; when completed, use included screw and copper washer to seal bung and then replace heat shield for unaltered finish • No pump or sampling tube required and allows both cylinders to easily be monitored at the same time • No welding PART # DESCRIPTION 3807-0445 Twin Scan 4 for 14-20 Touring, 11-20 Softail, 12-17 Dyna and 14-20 XL models w/ CAN data bus (all models with a 6-pin diagnostics connector) TWIN SCAN DIAGNOSTIC KIT • Communicates with ECM,TSSM and BCM to read, then clears diagnostic trouble codes • Activates ABS solenoids for proper brake bleeding and testing • Real-time display of engine sensors along with built-in data logging will store data for up to one hour • Data logging automatically triggered when a trouble code is set and shows the data before and after code is set • Programs and reads key fobs, programs PIN and disables security • Activates modules, lights, indicators fuel pump drain and electronic throttle sweep; tests different actuators, lights and indicators • Calibrates speedometer, removes new speedometer display of VinErr • Enables or disables settings in the ECM such as ACR (automatic compression release for performing engine compression testing), EITMS, cruise control, and active exhaust, reads and sets engine idle speed rpm • Enables or disables settings in the BCM for ignition switch, new radio installation, bank angle sensor for trike installs, program fog light function,ABS installation, and enables service state • Latest software will include the latest firmware for easy remote updating of the Twin Scan 4 • Includes two analog inputs with 0-20V or ± 200V range as well as two-channel oscilloscope capability for waveform display • Analog inputs can also be used for air/flow ratio (AFR) • Easy to navigate software • Requires use of a PC with Windows 7, Windows 8 or Windows 10 for display • Use probe kit (PART #3807-0189) to use scopemeter function; includes two insulation-piercing probes and 12V power adapters • Made in the U.S.A. NOTE: Models equipped with 12mm oxygen sensors will require 18mm weld nuts be installed in the exhaust system for use with the Twin Scan 3+ kit 18mm oxygen sensors. • Bung installation kit includes one hydraulic insertion tool, one drill bit, two O2 sampler blocks, tubing, 25 Rivnuts, 25 screws and 25 copper washers, all contained in plastic case • Refill kit PART #3807-0398 includes 25 each of bungs, plugs and copper washers, sold separately • Made in the U.S.A. 3807-0378
RkJQdWJsaXNoZXIy NDI5NTY=