BOLD MAGENTA part numbers are new for 2025 PARTSCANADA.COM 2025 | OFFROAD BIKES, STANDS & ACCESSORIES 86 DESCRIPTION PART # Universal Finger-Grip™ cradle 0603-0477 DESCRIPTION PART # RAM® Track Ball™ w/ T-bolt attachment 0603-0828 RAM® TRACK BALL™ WITH T-BOLT ATTACHMENT • B-size, 1” rubber ball molded to a high-strength composite base • Rubber friction washer and a stainless steel T-bolt for sliding into virtually any track system • Insert or slide the Track Ball™ into your track and twist the ball clockwise to tighten in place; twist counterclockwise to loosen DESCRIPTION PART # RAM® socket arm 0603-0942 RAM® SOCKET ARM •High-strength composite • Features a long, preassembled extension pole with 1” and 1.5” ball single open sockets • Socket ends swivel 360°, allowing you to rotate the camera adapter in any direction •Pole length (socket end to socket end) is 18” DESCRIPTION PART # Wireless charging holder 0636-0173 Wireless charging holder w/ U-bolt handlebar mount and hardwire charger 0636-0175 DESCRIPTION PART # Wireless charging holder w/ RAM® Twist-Lock™ suction cup 0636-0176 RAM® TOUGH-CHARGE™ WATERPROOF WIRELESS CHARGING HOLDERS • Powdercoated, marine-grade aluminum construction with stainless steel components and high-strength composite •Designed with spring-loaded X-Grip® technology; features an ‘X’ design that expands and contracts to secure nearly any phone while taking advantage of Qi wireless phone charging •Four arms feature rubber-coated caps that hold devices firmly in place • Includes a 1” B-size rubber ball with a diamond base, perfect for attaching any B-size RAM® double-socket arms • Connected Type-A male pigtail connector features an in-line switch that allows you to turn off the wireless charging module when not in use •Compatible with handheld devices that will fit the following dimensions: minimum width of 2.375” and maximum width of 3.25”, maximum depth of 0.875” •PART #s 0636-0173 include charging holder without mounting •PART #s 0636-0175 and 0636-0176 include a double-socket arm and mount; see chart below for specific mounts included •Safety device tether included that is recommended for outdoor applications 0636-0173 0636-0176 RAM® UNIVERSAL FINGER-GRIP™ CRADLE •This mount is designed to hold cell phones (check measurements below for dimensions) and electronic devices •High-strength composite •Comes with three sets of four flexible rubber-coated fingers placed along the sides to grip your device •The fingers open by squeezing the ends of the holder •The bottom of the holder includes a back plate that adds support to the device being held by the mount •Can also be used with several other phone accessories • The spine plate contains the universal AMPS and 1.5” x 2” hole patterns •Height dimensions: minimum with top and bottom plates is 5.25” and maximum with top and bottom plates is 6.0” •The top and bottom plates can be removed for larger devices • Spine plate dimensions: 3”W x 3” H •Using short-arm side clamps: max depth is 0.75”, min width is 1.25” and max width is 3.0” •Using medium-arm side clamps: max depth is 1.25”, min width is 1.5” and max width is 3.5” •Using long-arm side clamps: max depth is 1.6”, min width is 2.25” and max width is 3.5” •Made in the U.S.A. NOTE: Does not come with ball mount adapter; use PART #0603-0472 to mount to RAM® double-socket arm.
RkJQdWJsaXNoZXIy NDI5NTY=