BOLD MAGENTA part numbers are new for 2025 PARTSCANADA.COM 2025 | STREET HANDLEBARS & HAND CONTROLS HANDLEBARS & HAND CONTROLS 380 1 3/4” PIVOTING BAR RISERS FOR 1” HANDLEBARS FOR KTM 390 ADVENTURE/DUKE •1 3/4” center-to-center rise with 26 mm stem •Pivot forward or backward depending on rider preference •Black anodized finish NOTE: Always check and confirm that your machine has adequate cable and brake line length before installing handlebar risers. DESCRIPTION PART # 1 3/4” pivoting bar risers for 1” handlebars 0602-1355 ANTI-VIBE HANDLEBAR RISERS FOR BMW R1200/1250GSW/G SW ADVENTURE 13-20 •Great add-on for reducing hand tingling/numbness and for improving control across rugged terrain •Anti-Vibe Risers reduce bar vibration and also pivot Forward/Backward depending on rider preference •Designed to use the stock BMW caps/bolts on the top of the risers •Risers include replacement caps that will be used to tighten the stem of the riser to the OEM triple clamp •Work with stock cables – cable rerouting instructions included in package • 2” of rise •1 1/4” stem •Accept 1 1/4” handlebar •Made in the U.S.A. DESCRIPTION PART # Anti-Vibe risers 0602-0901 1 1/2” BARBACK RISERS FOR BMW R1200/1250GSW/ GSW ADVENTURE 13-20 •1 1/2” of total pullback (moves the bar approximately 1 1/4” up and 3/4” back from the OEM position) •Clear anodized finish •Include mounting hardware •Work with stock cables – cable rerouting instructions provided •Made in the U.S.A. DESCRIPTION PART # 1 1/2” barback risers 0602-0903 DESCRIPTION PART # Black anodized 0602-0904 DESCRIPTION PART # Gunmetal gray 0602-0905 DESCRIPTION PART # Machine finish 0602-0906 1 1/2” BARBACK RISERS FOR 1 1/8” HANDLEBARS •Move the handlebars 1 1/2” up and 1” back or forward from the OEM position (can be installed facing either direction) •Designed to work on any bike with a stock 1 1/8” Fatbar, parallel OEM bar clamps and open mounting area •Machined from 6061-T6 aircraft-grade billet aluminum • Engraved Rox logo for a clean and understated “factory” look •Always check and confirm that your machine has adequate cable and brake line length before installing handlebar risers • Machine finish, black anodized (matte finish) or gunmetal gray (matte finish) •These risers come with (2) step shims that allow the risers to mount to an OEM step down triple clamp, similar to the Honda Africa Twin •Include all mounting hardware and instructions •Made in the U.S.A. IMPORTANT: These risers cannot be installed on bikes with angled (eg.V-Shaped) OEM bar clamps. OEM bar clamps must be parallel and sized for M8 bolts in order for these risers to mount properly. These risers will not work on the Triumph Tiger. 0602-0906 0602-0905 0602-0904 Patent #6,920,806. NOTE: These risers aren’t designed to be positioned straight up because it can be difficult to access the BMW bolts to tighten the stem of the riser in place.
RkJQdWJsaXNoZXIy NDI5NTY=