BOLD MAGENTA part numbers are new for 2025 PARTSCANADA.COM 2025 | STREET ENGINE ENGINE 974 DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 4-6 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. OIL HOSE UPGRADE KITS •Sets your bike apart and gives your Jagg oil cooler a racy look with performance braided oil hoses straight from the track-ready line of Susa’s motorsport division • Available as bright stainless steel braided 6’ hose •Kit includes two aluminum hose separators in matching color and four aluminum hose finishers with integrated worm-drive clamps in matching color V-STAR OIL FILTER RELOCATION KIT •Eliminates the need to remove the exhaust system •Comes pre-assembled by trained technicians to reduce costly errors and helps ease the installation process •#8 lines that equal or exceed factory specifications for ideal oil flow • Braided stainless steel lines with chromed, threaded compression-sealed valves (not hose clamps) •For improved oil filtration a high-quality chrome oil filter with magnetized center is included DESCRIPTION PART # Stainless steel braided kit 0711-0237 REPLACEMENT OIL LINES DESCRIPTION PART # Bottom line 0711-0211 DESCRIPTION PART # Top/bottom line (pr.) 0711-0209 DESCRIPTION PART # Top line 0711-0210 RELOCATION KIT FITS MODEL PART # YAMAHA XVS1100A V-Star Classic/Custom 99-09 0712-0171 •Installs easily; simply trim hose to required length, slip hose finishers over ends of hose, press hose onto nipple and tighten hose clamp to achieve an easy and beautiful upgrade •Made in the U.S.A. •Manufactured from 6061-T6 billet aluminum •Works with engine guards •Easy to install and can turn a 1 1/2 hour oil change into a 20 minute job •Suggested replacement filter is PART #KN-303C; sold separately •Oil lines sold separately MANUAL OIL BYPASS VALVE • Acts as a manual thermostat, allowing you to bypass the oil cooling system for cold-weather riding or for faster warm-ups on cool days • Durable, anodized billet aluminum construction •Knurled grip knob •Works with all oil coolers •Compact in-line installation • Service kit contains replacement O-rings, snap-ring retaining clip for manual bypass knob and spare decal •Made in the U.S.A. NOTE: If oil hoses between the oil cooler and the oil source are too short, the oil cooler bypass valve may not fit in the oil lines. Jagg bypass valves require at least 3” of straight hose. DESCRIPTION PART # Manual oil bypass valve 0713-0215 STEEL BASE CRANKCASE VENTS •One-piece design for competition use only • Can be mounted remotely, but will require vent hoses and clamps •Vent diameter 3/8” OD; filter measures 2” OD x 1 1/2” high •Made in the U.S.A. DESCRIPTION PART # 5/16” vent filter, chrome w/ stud 1011-1529 DESCRIPTION PART # 3/8” vent filter w/o stud 62-1000 62-1000 0712-0171 0711-0209
RkJQdWJsaXNoZXIy NDI5NTY=