BOLD MAGENTA part numbers are new for 2025 V-TWIN TOOLS PARTSCANADA.COM TIRE & SERVICE | 2025 409 PART # DESCRIPTION 3801-0292 For 84-20 Big Twin hydraulic tappet assemblies VACUUM LIFTER“PUMP UP”TOOL •Bleeds and pumps up hydraulic lifters • Special jar, designed for vacuum, holds up to four hydraulic lifters in a convenient tray •Apply the vacuum to fully bleed the lifters and have them ready to install •Removes the risk of using starting system to pump up the lifters or damage to the valve train at low rpm if the lifters are not fully bled •Made in the U.S.A. PART # DESCRIPTION 3801-0261 For L76-17 Big Twin (except M-Eight) TAPPET BLOCK/OIL PUMP ALIGNMENT TOOL • Big Twin tappet blocks do not have counter-bored bolt holes; therefore, when a tappet block is removed (or even just loosened) it should be reinstalled using an alignment tool to ensure that the lifters track properly on the camshaft •This tool makes the process quick and easy, ensuring the durability of your installation • Tool also aligns Twin Cam oil pump to the cam support plate; two tools required •Sold each •Made in the U.S.A. PART # DESCRIPTION DS-197077 For L76-17 Big Twin (except M-Eight) TAPPET BLOCK/OIL PUMP TO CAM PLATE ALIGNMENT TOOL •Used to align oil hole from crankcase to tappet block •Can also be used to align rocker box bases on Evolution head (requires two tools) • Aligns Twin Cam oil pump to cam support plate; two required •Sold each •Made in the U.S.A. PART # DESCRIPTION DS-198638 For 70-99 Big Twin TAPPET OIL SCREEN PLUG TOOL •Used to remove the tappet oil screen plug •Removes oil screen without removing exhaust •Made in the U.S.A. PART # DESCRIPTION 3801-0002 Tappet screen plug tool TAPPET SCREEN PLUG TOOL • For use on 70-99 Big Twin (except Twin Cam) with slotted screw tappet oil filter screen cover •Designed for use with 7/16” combination wrench to allow for maximum rotation without touching engine cases •O-ring design retains the tool in wrench or socket •Flange design allows downward force to be applied to tool •Can be used without removing exhaust pipes on most bikes •Tappets should be serviced every oil change PART # DESCRIPTION 3801-0318 For 17-20 M-Eight and 99-17 Twin Cam CYLINDER HOLD DOWN NUTS •Help to keep the cylinders in place when removing the heads from the engine • One end fits Twin Cam and the other fits M-Eight •Sold in a set of two •Made in the U.S.A. PART # DESCRIPTION DS-197009 Oil pump jig CRANKCASE OIL PASSAGE DRILLING JIG •Used to install S&S oil pumps on early motor cases •Jig is made from steel and heat-treated for durability •Made in the U.S.A.
RkJQdWJsaXNoZXIy NDI5NTY=