BOLD MAGENTA part numbers are new for 2025 PARTSCANADA.COM 2025 | TIRE & SERVICE V-TWIN TOOLS 412 PART # DESCRIPTION DS-196199 For 99-06 Twin Cam (except 06 Dyna) for removing/ installing cams and bearings; for 00-06 FXST/FL and L00-05 FXD to remove and install cams only CAMSHAFT REMOVAL/INSTALLATION TOOL •Used to remove and install camshafts and bearings •Provides precision alignment of camshafts in the support plate •Made in the U.S.A. PART # DESCRIPTION 3801-0061 For 06 Dyna and all 07-17 Twin Cam DS-196198 For 00-06 Twin Cam (except 06 Dyna) INNER CAM BEARING REMOVAL TOOLS •Used to remove inner cam bearing without damaging the crankcase •Designed to keep rollers from falling into the crankcase •Instructions included •Made in the U.S.A. PART # DESCRIPTION 3801-0060 For 06 Dyna and all 07-17 Twin Cam DS-196201 For 99-06 Twin Cam (except 06 Dyna) CAM/CRANK SPROCKET LOCK TOOLS •Designed to lock the camshafts and crankshaft sprockets when removing, replacing and torquing the sprocket bolts •Made of non-marring Delrin® •Instructions included •Made in the U.S.A. PART # DESCRIPTION 3801-0310 For M-Eight,Twin Cam and Evolution lifter bores LIFTER BORE MEASURING KIT •A set of precision-ground steel balls to accurately measure lifter bore diameter and bore roundness •Feuling recommends a lifter to lifter bore clearance of 0.001” to 0.0015” for optimum lifter performance • Includes sizes 0.8430”, 0.8435”, 0.8440”, 0.8445” and 0.8450” •Made in the U.S.A. PART # DESCRIPTION DS-196170 For 70-99 74” and 80” Big Twin and 70-03 XL CAM COVER PULLER •Used to remove the right side-case cover • Includes bracket, puller bolt and set screws •Made in the U.S.A. PART # DESCRIPTION 3801-0066 For 06 Dyna and all 07-17 Twin Cam CAM ASSEMBLY TOOL •Holds both cams in an upright position while lowering cam support plate over both guides and cam journal guides •Made from a non-marring material that will not damage cam surface •Made in the U.S.A. PART # DESCRIPTION 3801-0160 For 99-17 Twin Cam CAM BEARING INSTALLATION TOOL •Used to install the two inner cam bearings •Designed to press from the letter side of the inner cam bearing to eliminate any damage to the bearings, cam or case • Will set bearings 0.023” to 0.028” below case surface •Made in the U.S.A. PART # DESCRIPTION DS-196196 For 99-06 Twin Cam (except 06 Dyna) CAM CHAIN TENSIONER TOOL •Designed to unload the pressure on the primary and secondary chain tensioners •Also checks spring loads on chain tensioners •Includes instructions •Made in the U.S.A. DS-196201 3801-0061
RkJQdWJsaXNoZXIy NDI5NTY=