JANUARY 2023 FEATURED PRODUCTS PROTON 3 TURN SIGNALS AND FRONT RUN AND TURN SIGNALS • Design takes ease of mounting to a new level • The small and lightweight housing is attached to wherever you need it with the help of high-strength adhesive tape • Built with black housings, smoked lenses and amber LEDs • Front run and turn signals add white daytime running lights • Once the signals are installed, they will almost disappear until they are activated • E-approved • Turn signals are for front or rear use, run and turn signals are for front use • Signal width: .43" • Measures .47" W x .47" H x .87" D • Universal fitment for 12V systems • Sold in pairs PROTON TURN SIGNALS AND RUN/TURN SIGNAL MODULES • Mounting options are only limited by your creativity • With the smoked lens and small size, the turn signal can virtually disappear • This signal is only noticeable when activated • Run/turn signal modules feature white daytime running lights • E-approved • Turn signals are for use as front or rear turn signal; run/turn signals are for front use • Dimensions: diameter: .43"; width: .5" • Universal fitment for 12V systems • Sold in pairs DESCRIPTION PART NO. Turn signals 2020-2084 Front run/turn signals 2020-20851 DESCRIPTION PART NO. Turn signals 2020-2080 Front run/turn signals 2020-20811 DESCRIPTION PART NO. Apollo bullet run/turn/brake signal 2020-2104 DESCRIPTION PART NO. Apollo run/turn/brake signal modules 2020-2103 2020-2085 2020-2084 2020-2080 2020-2081 1 The Highsider PL Control Box CB2 PART #2050-0472 switches the position light off during the flashing process and goes on again after the flashing process (with a small delay). 1 The Highsider PL Control Box CB2 PART #2050-0472 switches the position light off during the flashing process and goes on again after the flashing process (with a small delay). APOLLO BULLET RUN/TURN/BRAKE SIGNAL • Features a black aluminum housing with a smoked lens • Two ultra-bright SMD LEDs are installed in the center • Outer ring consists of the new COB technology (Chip On Board) • E-approved • For rear use • Dimensions: A: .87", B: 1.34", D: 1.57", Thread bolt M8 x .67" • Sold in pairs APOLLO RUN/TURN/BRAKE SIGNAL MODULES • Built for custom mounting in multiple locations • Includes a black aluminum ring with smoked lenses • Center of light features two ultra-bright SMD LEDs • Outer ring consists of COB LEDs (Chip On Board) • The semiconductors are bonded directly to a printed circuit board • This module comes with a black anodized aluminum ring that fits over the base body • Dimensions: A1: .51" (13mm), A2: .35" (9mm), D1: .86" (22mm), D2: .78" (20mm) • Thread Stud: M8 x 012mm • Sold in pairs Note: The unit can be installed flat without the aluminum ring, leaving only the lens visible. This requires drilling a .79" (20 mm) wide hole. Alternatively, the unit can be mounted with the aluminum ring on e.g. a retaining plate on the vehicle.
RkJQdWJsaXNoZXIy NDI5NTY=